The Flow

28.05.2018
00:48
Comments Off on The Flow

When using it will require less all piping work, electrical wiring, the cost and effort. In contrast, many setup with ball valves, for example, need not only in the ball valve, but also in the drive and automatic control solenoid valve. essful. Members should take into account key indicators. This type of valve, , working environment, valve size, pressure in the pipe line, the environment, operating temperature, voltage required, and additional requirements, such as a special case of electromagnets. Consider some of the most common problems. Exceeding the rated pressure.

Higher nominal operating pressure does not mean that this valve is better. You just need to choose the valve specifications which are best suited to operating conditions in a particular area of his application. Higher nominal value may not only be a waste of money, it can actually damage the operation of the valve due to insufficient pressure differential (see below) or other problems. Two-way, it does not bidirectional. Two-way valves are only suitable for the flow going in one direction. Install them only to serve the flow going in the direction marked by the manufacturer, in Otherwise, the operation may be unstable or impossible. Contamination of the environment.

Contamination of the working environment in the pipeline line is one of the most common causes of problems solenoid valve. Most of the valves is designed to use a clean working environment. Refer to the manufacturer's recommendations regarding any exceptions. If possible, install valves, placing them electromagnets in an upright position to prevent the accumulation of foreign matter in the tube core.

Comments are closed.

Powered by WordPress and Artsavius Theme